What Company is Most Likely to Make This Diorama Set ??? (1 Viewer)

[PanzerAce1944]

For all of us LAH Berlin 38' collectors this set would be a great addition. Done as a center with 2 matching sides
What company do you think will produce these first if done. ?

 

[uksubs]

Going by what been made so far I think all the companys will make them including a winter version ^&grin

 

[Mitch]

Well, I would have to say CS its in their scope of what they have done and, are doing with their new buildings. I would hope they offer a larger number of side pieces available than centre ections as it should really have two or three at either side for full effect
Mitch

 

[PanzerAce1944]

Well, I would have to say CS its in their scope of what they have done and, are doing with their new buildings. I would hope they offer a larger number of side pieces available than centre ections as it should really have two or three at either side for full effect
Mitch

I was thinking the same thing !

 

[ostrein]

Certainly the new Reichskanzlei would be great - with a number of side units. But I think the problem is the centre unit: Its very deep. How do you want to make the side units without using too much material then?

Those of you who already own the CS Reichskanzlei Entrance know the size and weight of this pice alone. And this is only 1/3 of the entrance unit.

I don't think anyone will produce the Reichskanzlei on a larger run. Better to ask a medeller to do a custom build IMO.

Oliver

 

[Mitch]

oliver...

Perhaps this depth issue could be overcome by doing the middle section with entrance and stairs seperate. This would mean it would be a two piece centre release and, would ease the difficulty in making this section. Doing it this way would also allow the side sections to remain single depth and not look too out of place

Just a thought
Mitch

 

[PanzerAce1944]

oliver...

Perhaps this depth issue could be overcome by doing the middle section with entrance and stairs seperate. This would mean it would be a two piece centre release and, would ease the difficulty in making this section. Doing it this way would also allow the side sections to remain single depth and not look too out of place

Just a thought
Mitch

Sounds like a very effective solution. The center piece would be the most expensive out of the 3 but that was the case with the CS Lichterfeld set. No problem here.
Manufacturers lets bring it !!!