New Releases For October 2016 Knights Of The Skies (1 Viewer)

jjDesigns

Sergeant
Joined
Apr 21, 2014
Messages
654
KNIGHTS OF THE SKIES


The Sopwith Triplane was a British single seat fighter aircraft designed and manufactured by the Sopwith Aviation Company during the First World War. It was the first military triplane to see operational service. The Triplane joined Royal Naval Air Service squadrons in early 1917 and was immediately successful. It was nevertheless built in comparatively small numbers and was withdrawn from active service as Sopwith Camels arrived in the latter half of 1917.
The Triplane's combat debut was highly successful. The new fighter's exceptional rate of climb and high service ceiling gave it a marked advantage over the Albatros D.III, though the Triplane was slower in a dive. The Germans were so impressed by the performance of the Triplane that it spawned a brief triplane craze among German aircraft manufacturers, resulting in the successful Fokker DR1.
Pilots nicknamed the aircraft the Tripehound or simply the Tripe.


ACE30.JPG

ACE-30
KNIGHTS OF THE SKIES,
SOPWITH TRIPLANE
N533 “C” “BLACK MARIA”,10 NAVAL SQUADRON,
DROGLANDT, FRANCE, JUNE 1917,
(1pc)



On July 27th 1917, Raymond Collishaw achieved 2 victories in this triplane, which was one of only six Triplanes armed with twin Vickers guns.


ACE30a.JPG

The Triplane was famously flown by No. 10 Naval Squadron's "B" Flight, better known as "Black Flight." This all-Canadian flight was commanded by the ace Raymond Collishaw. Their aircraft, named Black Maria, Black Prince, Black George, Black Death and Black Sheep, were distinguishable by their black-painted fins and cowlings.
Black Flight claimed 87 German aircraft in three months while equipped with the Triplane. Collishaw himself scored 34 of his eventual 60 victories in the aircraft, making him the top Triplane ace.


ACE30b.JPG

For a variety of reasons, the Triplane's combat career was comparatively brief. In service, the Triplane proved difficult to repair. The fuel and oil tanks were inaccessible without substantial disassembly of the wings and fuselage. Even relatively minor repairs had to be made at rear echelon repair depots. Moreover, spare parts became difficult to obtain during the summer of 1917, and No. 1 Naval Squadron's complement was reduced from 18 to 15 aircraft.
The Triplane also gained a reputation for structural weakness because the wings sometimes collapsed in steep dives. This defect was attributed to the use of light gauge bracing wires in the 46 aircraft built by subcontractor Clayton & Shuttleworth.
Another drawback of the Triplane was its light armament. While contemporary Albatros fighters were armed with two guns, most Triplanes were armed with a single synchronised Vickers machine gun. Efforts to fit twin guns to the Triplane met with mixed results. Clayton & Shuttleworth built six experimental Triplanes with twin guns.


ACE30c.JPG


The second new allied pilot set. The two allied pilots in set ACEBP03 are designed to fit all current allied planes. Unfortunately the new ACEBP-04 wounded pilots do not fit the new
ACE-30 Sopwith Triplane.


ACEBP04.JPG

ACEBP-04
KNIGHTS OF THE SKIES,
WOUNDED ALLIED PILOTS,
(2 pcs)


More to follow...........................................
 
BGC26PIC.JPG

A Hucks Starter is an auxiliary power unit, almost always a motortruck, that provides initial power to start up piston aircraft engines. Such Hucks starter trucks can be considered a mechanical replacement for a member of the groundcrew who would have spun an aircraft's propeller by hand. This is because of the starter truck's position in front of the airplane when starting, much like a groundcrew member, and were commonly used when aircraft engines became too large to be easily started by hand.
The power is transmitted to the aircraft via a power take-off shaft, much like those found on the drive trains of rear-wheel drive vehicles, or agricultural machines. The shaft of the starter fits into a special protruding hub incorporating a simple projecting claw clutch on the center of the airplane's propeller assembly. When engaged, the power of the truck's engine is transmitted to the aircraft engine until start up, whereupon the faster speed of the now-running engine disengages the clutch, and then the starter truck clears the area prior to take-off.
The device was named after its inventor Bentfield Hucks, who was a captain in the Royal Flying Corps at the time
In the Royal Air Force service, Hucks Starters were based on Ford Model T trucks, which were in widespread use and familiar to ground crew.

BGC26A.JPG

BGC-26A
KNIGHTS OF THE SKIES,
FORD MODEL T, HUCKS STARTER,
(1pc)


The Huck Starter with 2 crew. The crew figures will be available at a later date.

BGC26CREW.JPG



BGC26B.JPG

BGC-26B
KNIGHTS OF THE SKIES,
FORD MODEL T, HUCKS STARTER,
(1pc)




BGC26BREAR.JPG


** FOR FURTHER INFORMATION PLEASE CONTACT YOUR LOCAL DEALER**

** PLEASE CHECK WITH YOUR LOCAL DEALER FOR NEW SETS PREVIEWED AT THE CHICAGO TOY SOLDIER SHOW, AND IF YOU ARE AT THE SHOW PLEASE ENTER THE TREASURE HUNT!**
 
A fantastic choice of aircraft here. It really is an iconic fighter, especially in the colors and markings of the Black Flight, led by Collishaw. Great choice by John. I have always liked the Sopwith tripe and had several of the Aurora version as a kid, when I built my own Black Flight. This will be a must have and a really important addition to my Allied air force. Love it. -- Al
 
Freaking Awesome! I'd been looking for a WW Sopwith Triplane, but it sold out and the kits are selling for $160 on sleezbay. I'm so relieved.:D Also love the vehicle.:cool:

-Moe
 
Well Moe, Al, we're walking in tall cotton now (my wife is from Mississippi)! :wink2: The tripe and vehicle are must haves. The starting vehicle is possibly the most innovative model I've seen since the pigeon wagon. Chris
 
The starting vehicle is possibly the most innovative model I've seen since the pigeon wagon. Chris

attachment.php



Tell you what Chris, Rube Goldberg's got nothing on Bentfield Hucks!:wink2:

-Moe
 
Fits the Hucks starter only at SPAD's or also on the older Camel / SE.5a / Nieuport 17?


View attachment 198482

A Hucks Starter is an auxiliary power unit, almost always a motortruck, that provides initial power to start up piston aircraft engines. Such Hucks starter trucks can be considered a mechanical replacement for a member of the groundcrew who would have spun an aircraft's propeller by hand. This is because of the starter truck's position in front of the airplane when starting, much like a groundcrew member, and were commonly used when aircraft engines became too large to be easily started by hand.
The power is transmitted to the aircraft via a power take-off shaft, much like those found on the drive trains of rear-wheel drive vehicles, or agricultural machines. The shaft of the starter fits into a special protruding hub incorporating a simple projecting claw clutch on the center of the airplane's propeller assembly. When engaged, the power of the truck's engine is transmitted to the aircraft engine until start up, whereupon the faster speed of the now-running engine disengages the clutch, and then the starter truck clears the area prior to take-off.
The device was named after its inventor Bentfield Hucks, who was a captain in the Royal Flying Corps at the time
In the Royal Air Force service, Hucks Starters were based on Ford Model T trucks, which were in widespread use and familiar to ground crew.

View attachment 198481

BGC-26A
KNIGHTS OF THE SKIES,
FORD MODEL T, HUCKS STARTER,
(1pc)


The Huck Starter with 2 crew. The crew figures will be available at a later date.

View attachment 198483



View attachment 198484

BGC-26B
KNIGHTS OF THE SKIES,
FORD MODEL T, HUCKS STARTER,
(1pc)




View attachment 198485


** FOR FURTHER INFORMATION PLEASE CONTACT YOUR LOCAL DEALER**

** PLEASE CHECK WITH YOUR LOCAL DEALER FOR NEW SETS PREVIEWED AT THE CHICAGO TOY SOLDIER SHOW, AND IF YOU ARE AT THE SHOW PLEASE ENTER THE TREASURE HUNT!**
 
Fits the Hucks starter only at SPAD's or also on the older Camel / SE.5a / Nieuport 17?

From the looks of it, the arm may be adjustable. To be certain, you might want to email Jenkins. I'm sure that they'll get back to you before the replica is released. "They" is John, BTW.;)

-Moe
 
Fits the Hucks starter only at SPAD's or also on the older Camel / SE.5a / Nieuport 17?
The point of the Hucks starter was as an assist to starting engines that had grown bigger and heavier as the airplane developed during the war. The rotary engines in the Camels and Nieuports were relatively small and light and were easily started by the man turning the prop by hand. The later inline engines, like found in the Bristol F2b's, DH-9's, and others, were larger and heavier and were a lot more difficult to start by hand turning the prop. That is what the Hucks starter was developed for. The design wasn't even patented until 1919 or so and the Hucks starter saw most of it's use in the 1920's and early 30's before the more sophisticated starters, such as the hand crank, were developed. -- Al
 
View attachment 198482

a hucks starter is an auxiliary power unit, almost always a motortruck, that provides initial power to start up piston aircraft engines. Such hucks starter trucks can be considered a mechanical replacement for a member of the groundcrew who would have spun an aircraft's propeller by hand. This is because of the starter truck's position in front of the airplane when starting, much like a groundcrew member, and were commonly used when aircraft engines became too large to be easily started by hand.
The power is transmitted to the aircraft via a power take-off shaft, much like those found on the drive trains of rear-wheel drive vehicles, or agricultural machines. The shaft of the starter fits into a special protruding hub incorporating a simple projecting claw clutch on the center of the airplane's propeller assembly. When engaged, the power of the truck's engine is transmitted to the aircraft engine until start up, whereupon the faster speed of the now-running engine disengages the clutch, and then the starter truck clears the area prior to take-off.
The device was named after its inventor bentfield hucks, who was a captain in the royal flying corps at the time
in the royal air force service, hucks starters were based on ford model t trucks, which were in widespread use and familiar to ground crew.

View attachment 198481

bgc-26a
knights of the skies,
ford model t, hucks starter,
(1pc)


the huck starter with 2 crew. The crew figures will be available at a later date.

View attachment 198483



View attachment 198484

bgc-26b
knights of the skies,
ford model t, hucks starter,
(1pc)




View attachment 198485


** for further information please contact your local dealer**

** please check with your local dealer for new sets previewed at the chicago toy soldier show, and if you are at the show please enter the treasure hunt!**

is that a fuel truck i see in the background?
 
Thank you for your answer.
Then it make sense that it fits only for the SPAD
So properly speaking, it is not for a WWI display because for that time it was not in use?
Hucks died November 1918 at Wikipedia under Hucks starter they write that it was used in the 20s/30s...

The point of the Hucks starter was as an assist to starting engines that had grown bigger and heavier as the airplane developed during the war. The rotary engines in the Camels and Nieuports were relatively small and light and were easily started by the man turning the prop by hand. The later inline engines, like found in the Bristol F2b's, DH-9's, and others, were larger and heavier and were a lot more difficult to start by hand turning the prop. That is what the Hucks starter was developed for. The design wasn't even patented until 1919 or so and the Hucks starter saw most of it's use in the 1920's and early 30's before the more sophisticated starters, such as the hand crank, were developed. -- Al
 
Thank you for your answer.
Then it make sense that it fits only for the SPAD
So properly speaking, it is not for a WWI display because for that time it was not in use?
Hucks died November 1918 at Wikipedia under Hucks starter they write that it was used in the 20s/30s...

From what I have read, by the time the Hucks starter was delivered to squadron locations the war was over. It was primarily used in the 1920's and into the 1930's. It was even being used by the Russians at the start of WWII.

Mike
 
From what I have read, by the time the Hucks starter was delivered to squadron locations the war was over. It was primarily used in the 1920's and into the 1930's. It was even being used by the Russians at the start of WWII.

Mike
That was the impression I had, also. I have seen photos of the starters used by the Russians for their Polikarpov radial engined fighters and the Japanese had similar starters for their radial engine fighters like the Ki-27. Many photos exist showing them in use during the Nomonhan incident, and later. -- Al
 
Hi.
From the photos, are there two variants? One seems to be green, the other grey? Maybe it's just my eyesight!

Pete
 

Users who are viewing this thread

Back
Top